Title: Revised zone method R-value calculation for precast concrete sandwich panels containing metal wythe connectors
Date: September-October, 2008
Volume: 53
Issue: 5
Page number: 86-100
Author(s): Byoung-Jun Lee, Stephen Pessiki
https://doi.org/10.15554/pcij.09012008.86.100

Click here to access the full journal article

Abstract

Metal wythe connectors are used in a typical precast concrete sandwich panel to tie concrete wythes together and to keep the panel intact during handling and in service. Connectors interrupt the continuous insulation layer, reducing the effectiveness of the insulation. In current practice, thermal resistance ( R -value) of such a panel is calculated from the zone method. However, the zone width parameter W used in the zone method was originally developed for metal-frame structures and an accurate R -value cannot be estimated for precast concrete sandwich panels containing metal wythe connectors. This paper proposes a new zone-width equation for use in the he R -value of precast concrete sandwich panels containing the metal wythe connectors. The proposed zone width W_n was derived from the results of a series of finite element heat-transferanalyses intended to quantify the influence of several key parameters on W_n. It was found that the zone method with the proposed zone-width equation can accurately estimate R-values of a precast concrete sandwich panel containing metal wythe connectors. Also, the proposed zone-width equation can effectively consider the effects of metal wythe connector sizes and spacing, material conductivities, and panel thicknesses in the zone method of R-value computation.

References

1. Gabor, L. 1971. Thermal Steady State Analysis. Build International, V. 4, No. 1 (January–February): pp. 58–63.

2. McCall, W. C. 1985. Thermal Properties of Sandwich Panels. Concrete International, V. 7, No. 1: pp. 35–41.

3. PCI Committee on Precast Sandwich Wall Panels. 1997. State-of-the-Art of Precast/Prestressed Sandwich Wall Panels. PCI Journal, V. 42, No. 2 (March– April): pp. 92–134.

4. Holman, J. P. 2002. Heat Transfer. 9th ed. New York, NY: McGraw-Hill.

5. American Society of Heating, Refrigerating and Air- Conditioning Engineers (ASHRAE). 1997. ASHRAE Handbook: Fundamentals. I-P ed. Atlanta, GA: ASHRAE.

6. PCI Industry Handbook Committee. 2004. PCI Design Handbook: Precast and Prestressed Concrete. 6th ed. Chicago, IL: PCI.

7. Lee, Y. J. 2003. Development of the Characteristic Section Method to Estimate R-values of Precast Concrete Sandwich Wall Panels. MS thesis, Department of Civil and Environmental Engineering,  Lehigh  University, Bethlehem, PA.

8. Lee, Y. J., and S. Pessiki. 2003. Development of the Characteristic Section Method to Estimate R-values of Precast Concrete Sandwich Wall Panels. ATLSS report no. 03-06. Bethlehem, PA: Lehigh  University.

9. ASTM Committee C-16. 1989. ASTM C236-89: Standard Test Method for Steady-State Thermal Performance of Building Assemblies by Means of a Guarded Hot Box. In Annual Book of ASTM  Standards, V. 04.06. West Conshohocken, PA: ASTM. 

10. Lee, B. J. 2003. Development of a Precast PrestressedConcrete Three-Wythe Sandwich Wall Panel. PhD diss. Department of Civil and Environmental Engineering, Lehigh University, Bethlehem,  PA.

11. Lee, B. J., and S. Pessiki. 2004. Analytical Investigation of Thermal Performance of Precast Concrete Three-wythe Sandwich Wall Panels. PCI Journal, V. 49, No. 4 (July–August): pp. 88–101.