Title: Design of Spandrel Beams
Date: September-October, 1986
Volume: 31
Issue: 5
Page number: 76-124
Author(s): Gary J. Klein
https://doi.org/10.15554/pcij.09011986.76.124
Click here to access the full journal article
Abstract
A study of the behavior and design 01 precast spandrel beams was undertaken. This research project was primarily directed toward spandrel beams commonly used in parking structures. Both L-beams and pocket spandrels were included in the study. The research included background investigation of design practices, analytical studies using finite element models, and full-scale load tests of two L-beams and one pocket spandrel. All three test specimens were 72 in. high, 8 in. wide and 28 ft long. The target design loads were based on 90 psf dead load and 50 psf live load, which are typical for a double tee parking structure with 60 ft spans.
References
1. MacGregor, James G. (Chairman), "The Shear Strength of Reinforced Concrete Members," by the Task Committee on Masonry and Reinforced Concrete of the Structural Division," Journal of the Structural Division, ASCE, V. 99, No. ST6, Proceedings Paper 9791, June 1973, pp. 1091-1187.
2. PCI Design Handbook - Precast and Prestressed Concrete, Third Edition, Prestressed Concrete Institute, Chicago, Illinois, 1985.
3. Notes on ACI 318-83, Fourth Edition, Portland Cement Association, Skokie, Illinois, 1984, pp. 14-28.
4. ACI Committee 318, "Building Code Requirements `or Reinforced Concrete (ACI 318-83)," American Concrete Institute, Detroit, Michigan, 1983.
5. Cleland, Ned M., "Identification of Secondary Behavior in Combined Bending, Shear, and Torsion of Reinforced Concrete Ledger Beams," PhD Dissertation, University of Virginia School of Engineering and Applied Science, August 1984. See also "Behavior of Precast Reinforced Concrete Ledger Beams," by Cleland, Ned M., and Baber, Thomas T., PCI JOURNAL, V. 31, No. 2, March- April 1986, pp. 96-117.
6. Iverson, James K., and Pfeifer, Donald W., "Bearing Pads for Precast Concrete Buildings," PCI JOURNAL, V. 30, No. 5, September-October 1985, pp. 128-154.
7. Zia, Paul and McGee, W. Denis, "Torsion Design of Prestressed Concrete," PCI JOURNAL, V. 19, No. 2, March- April 1974, pp. 46-65.
8. PCI Design Handbook - Precast and Prestressed Concrete, Second Edition, Prestressed Concrete Institute, Chicago, Illinois, 1978.
9. Zia, Paul and Hsu, Thomas, "Design for Torsion and Shear in Prestressed Concrete," Preprint 3424, ASCE Chicago Exposition, October 1978.
10. Raths, Charles H., "Spandrel Beam Behaviorand Design," PCI JOURNAL, V. 29, No. 2, March-April 1984, pp. 62-131.
11. Collins, Michael P., and Mitchell, Denis, "Shear and Torsion Design of Prestressed and Non-Prestressed Concrete Beams," PCI JOURNAL, V. 25, No. 5, September-October 1980, pp. 32-100.
12. Mirza, Sher Ali, and Furlong, Richard W., "Serviceability Behavior and Failure Mechanisms of Concrete Inverted TBeam Bridge Bentcaps," ACI Journal, Proceedings V. 80, No. 4, July-August 1983, pp. 294-304.
13. Mirza, S. A., and Furlong, R. W., "Designof Reinforced and Prestressed Concrete Inverted T Beams for Bridge Structures," PCI JOURNAL, V. 30, No.4, July-August 1985, pp. 112-137. See also Discussion of Ref. 13 by Basile G. Rabbat and S. A. Mirza and R. W. Furlong in PCI JOURNAL, V. 31, No. 3, May-June 1986, pp. 157-163.
14. Krauklis, A. T., and Guedelhofer, O. C., Discussion of "Spandrel Beam Behavior and Design" (Ref. 10), PCI JOURNAL, V. 30, No. 5, September-October 1985, pp. 171-174.
15. Hanson, John M., "Square Openings in Webs of Continuous Joists," PCA Research and Development Bulletin, Portland Cement Association, Skokie, IIlinois, 1969, 14 pp.
16. Klein, Cary J., "Design of Spandrel Beams," PCISFR.AD Project No, 5, Prestressed Concrete Institute, Chicago, 11- linois, 1986, 100 pp.
17. Rice, Paul F., et al, Structural Design Guide to the ACI Building Code, Third Edition, Van Nostrand Reinhold Co., Inc., New York, N.Y., 1985, 477 pp.